The clover clamp without chain Rimba #7674
These Nipple clamps with chain (pair) 'The clover clamp', also referred to as a "butterfly clamp", is of Japanese design and has the ability to provide increasing tension if pulled on. The clamp itself is flat, but about 10 cm by 5 cm in size. Using spring tension, the clamp is applied to the nipple and the tension of its spring holds the clamp in place. This clamp usually provides a very high pain level, and is usually only used by more advanced users. To increase tension on the nipples, small weights such as fishing line sinkers can be attached to the ends of the clamp. As increased pulling tension is applied to the clamp, it will cause the jaws of the clamp to close tighter depending on the amount of pull pressure. Another method is to use the clamps to keep a person in one place. If cord is tied from the clamp to a fixed place, the wearer of the clamps cannot move away because the clamps will tighten as they try to move. Eventually the clamps would be pulled off the nipples, but not before considerable pain and discomfort is felt.
Quality product from Holland
Metal Nipple Chain by Sextreme
Prickly feelings from soft till hard!28 cm long nipple chain with metal nipple clamps. Pressure strength adjustable.Length 42 cm, weight 42 g.
Sextreme Article nr. 05264280000 - Made in Germany
Adjustable nipple Clamps with chain by Rimba 7703
These light plastic nipple clamps can be very securely attached to the nipples. They can be adjusted very precisely and weigh very little, so the amount of pressure they exert can be very precisely tuned. However the stationary bar has spikes which will insure a tight hold and some piercing sensations. They come with a ring attached by a metal chains. Specifications: Fully extend the two bars are spread .75 inches apart. The clamp measures 1.5 inches in width.
Nipple clamps (pair) are also available without chain with key ring (Ri-7704).
Quality product from Holland
Similar in function to a clothespin, this individually sold nipple clip has vinyl coated tips and a thumbscrew for adjusting tension. Six removable 1 ounce magnetic weights can be used to vary gravity‘s pull.
When placed just so, this single alligator style clamp is designed to add graduated pressure to the sensual areas of your plaything. You decide if they deserve light pressure or an intense pinch. Onus comes to you with a rubber tipped clamp with a twist-up adjuster, and 6 removable 1 oz. magnet weights. Your plaything will enjoy the customizable weight of the magnets alongside the graduated pressure.
Measurements: 3 inches in total length, clamp opens to approximately 0.5 inches wide
Material: Steel, vinyl, and magnets
Color: Silver
Note: Sold in singles, please order 2 for a pair