The Crush Electro Ball Press is a combination electrosex device and ball pressuring system

Crush Electro Ball Press CBT Board Specs and Benefits:

• Size: 5.5 inches in length, 5 inches wide
• Material: ABS, steel, rubber
• Color: Black
• Batteries: Requires 3v cell battery, included
• Designed to offer electrostimulation as well as apply pressure to the balls
• Cycle through 10 modes of intensity and 6 rhythmic patterns

Manual for the Crush Electro Ball Press CBT Board, SKU: AE277:

1. Install the Battery
   The device requires one 3V CR2032 lithium coin cell for power.
   Slide open the battery compartment on the back.
   Insert the CR2032 battery with the + side facing up.
2. Prepare the Area
   Proper preparation prevents skin irritation and improves conductivity.
   Clean the skin with mild soap and water, trim (don’t shave) hair to avoid hotspots and dry the area completely before use.
3. Apply Conductive Gel
   Conductive gel ensures even electrical contact and prevents stinging.
   Use a thin layer of water‑based conductive gel. (Avoid silicone or oil-based products) Cover the entire contact surface evenly.
4. Position the Board
   Correct placement ensures safe and effective stimulation.
   Place the testicles between the plates. Adjust the press tension slowly and gently.
   Ensure no pinching or sharp pressure points occur.
5. Connect to Your Power Box
   Click the included powerbox onto the CBT Board using the push buttons and then turn the powerbox to 'ON'.
   There are 6 programs; each program is indicated by the red LED.
   Select a program and activate it by pressing 'ON'. You can now switch between the different programs.
   You can increase the intensity step by step using the 'ON/INC' button. For each step higher intensity, click the 'ON/INC' button once.
   Turn it off using the 'OFF/DEC' button.
6. Start Stimulation Safely
   Begin with the lowest intensity and increase gradually. Turn on the power box at the lowest setting. Increase intensity slowly until you feel a steady, non‑painful tingle.
   Stop immediately if you feel sharp pain, burning, or numbness.
7. Aftercare
   Proper aftercare prevents irritation and speeds recovery.
   Turn off the power box before disconnecting.
   Remove the board gently. Wipe the skin and apply aloe or a soothing lotion.
   Clean the device with mild soap and water (no submersion).